Convotherm OES 6.10 Installationshandbuch Seite 61

11. Optional Equipment
Observe and instruct the user that the
•
grease collection tub must be removed
from the unit and the drain plug for the
grease drain must be closed before an
automatic steam generator cleaning,
an automatic cleaning or a cleaning
with the hand shower is performed.
Otherwise the entire water from the
steam generator or cleaning will end up
in the grease collection container. This
can cause the grease collection
container to overflow!
Prepare the unit for grilling chickens as
•
Picture 28
follows:
– Open the drain plug →
additional grease drain in the oven
floor.
– Slide the grease collecting tub →
into the unit (not into the hanging
rack, but directly onto the oven
floor).
Attention: The drain for the
grease collection tub must be in
the middle over the grease drain
on the oven floor.
– Place the partitioning trays in the
oven →
– After preheating, load the filled
chicken grids →
for the
.
.
11.5 Connection of a
communication interface
All CONVOTHERM combi steamer
•
units are fitted with a RS232
communication interface.
To connect a PC by means of this
RS232, a special interface cable is
necessary.
A separate communication module is
•
required to connect a CONVOTHERM
to a network. The communication
module is installed as follows:
Module A
– RS232 (connect with a standard 9-
pole connection)
– RS485
– USB interface
Module B
– RS232 (connect with a standard 9-
pole connection)
– RS485
– USB interface
– Ethernet
Refer to the installation instructions for
•
the communication module in the
Service documents.
57
EN