B) Setting Up A Master-Slave Chain; Mains Connection - Renkforce PowerPar 7 x 8 W PAR Bedienungsanleitung

b) Setting up a Master-Slave Chain

The effect light can be operated controlled by a DMX controller or in a master-slave chain. In that case, the
integrated controller of the master device controls the connected slave devices.
• Connect the DMX OUT port of the master device to the DMX IN port of the first slave device.
• Connect the DMX OUT port of the first slave device to the DMX IN port of the subsequent slave device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT connection of the last slave device (as
described in section "Connection of a DMX Controller").

10. Mains Connection

The mains socket to which the effect light is connected must be close to the device and easily
accessible to quickly separate the device from the mains voltage in case of an error.
Ensure that the voltage indication on the effect light matches the mains voltage of your power
supply. Never try to operate the device with any other voltage.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause po-
tentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Never overload the mains output. Up to 10 same devices can be connected here. Never connect
other devices or more devices of the same kind than indicated here. This would cause overload
of the connection.
• Connect the low-voltage connector of the mains cable to the mains socket of the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, it takes up operation.
• Through the mains output, other effect spotlights can also be connected to the mains. For this, plug in a
mains extension (available in specialist stores) in the mains output and connect it to the mains connec-
tion of the next device.
31