Replacing The Lamp; Troubleshooting - Koenic KBO 23311 Benutzerinformation

18
sure the glass slides out of the
supports completely.
8. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the glass panel and the oven door. Do the
above steps in the opposite sequence.
Make sure that you install the internal
glass panel in the seats correctly.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The cooking zones do not
operate.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.

Replacing the lamp

1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
A
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cooking sur‐
face.
The oven is deactivated.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
WARNING! Risk of electric
shock.
The lamp can be hot.
CAUTION! Always hold the
halogen lamp with a cloth to
prevent grease residue from
burning on the lamp.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.