Stihl Al 101 Charger Conformity Notice; Conformity Mark; General Power Tool Safety Warnings; Introduction - Stihl MSA 120 C Gebrauchsanleitung

24 General Power Tool Safety Warnings

23.2 STIHL AL 101 Charger Conformity Notice

This charger is manufactured and put on the market in
accordance with the following directives: 2006/95/EC (up to
19.04.2016), 2014/35/EU (from 20.04.2016), 2004/108/EC (up
to 19.04.2016), 2014/30/EU (from 20.04.2016) and 2011/65/
EU.
The complete EC Declaration of Conformity is available from
ANDREAS STIHL AG & Co. KG.
ANDREAS STIHL AG & Co. KG
Badstrasse 115
D-71336 Waiblingen
Germany

23.3 Conformity Mark

All relevant requirements set down in the Harmonized
Standards of the European Community are fulfilled.
All conformity regulations and technical requirements
applicable in the Eurasian Economic Community are
fulfilled.
24 General Power Tool Safety Warnings

24.1 Introduction

This chapter reproduces the pre-formulated, general safety
precautions specified in the EN 60745 European standard for
hand-held motor-operated electric tools.
STIHL is obliged to publish these texts.
The safety precautions and warnings on avoiding an electric
shock given under "2) Electric Precautions" do not apply to
STIHL cordless electric power tools.
MSA 120 C
WARNING
Read all safety warnings and instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/
or serious injury. Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.

24.2 Work area safety

a) Keep work area clean and well lit. Cluttered or dark areas
invite accidents.
b) Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes.
c) Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.

24.3 Electrical safety

a) Power tool plugs must match the outlet. Never modify the
plug in any way. Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators. There
is an increased risk of electric shock if your body is earthed
or grounded.
c) Do not expose power tools to rain or wet conditions. Water
entering a power tool will increase the risk of electric
shock.
English
87