Checking The Built-In Battery; Operating The Blower; Holding And Controlling The Blower; Blow-Sweeping - Stihl BGA 45 Gebrauchsanleitung

English

10.2 Checking the Built-In Battery

► Press the button.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use the blower and
contact your STIHL servicing dealer.
There is a malfunction in the built-in battery.

11 Operating the Blower

11.1 Holding and Controlling the Blower

► Hold and control the blower with one hand on the control
handle - wrap your thumb around the handle.

11.2 Blow-Sweeping

► Point the nozzle at the ground.
36
► Walk slowly and steadily forwards.

12 After Finishing Work

12.1 After Finishing Work
► Switch off the blower and remove the activation key.
► Clean the blower.

13 Transporting

13.1 Transporting the Blower

► Switch off the blower and remove the activation key.
► Carry the blower by the control handle.
► Transporting the blower in a vehicle: Secure the blower to
prevent it turning over or shifting.
► If the blower need to be packed: Observe the following
points when packing the blower:
– Packaging or transport box must be non-conductive.
– Make sure the blower cannot shift inside the packaging
or transport box.
– Secure the packaging or transport box so that the
packaging or transport box cannot move.
Owing to the built-in battery, the blower is subject to the
requirements for transporting dangerous goods. The blower
is classified as UN 3481 (lithium-ion batteries in equipment)
and has been tested in accordance with UN Manual of Tests
and Criteria, Part III, sub-section 38.3.
For transport regulations see www.stihl.com/safety-data-
sheets
11 Operating the Blower
0458-719-9621-A