urmet domus DS1093-054 Kurzanleitung Seite 27

Select the Add button to enter IP Channel Settings menu, shown in Figure.
4.
Select the IP device from the list. The devices found in the list are those supported by SADP and are found by
5.
the DVR. If no devices were found, you may manually enter the camera parameters in the fields below.
Enter IP camera parameters. This includes the IP address, ports, user name and password of the IP camera.
6.
Select OK to save and return to the Camera Management menu.
7.
If IP camera was added successfully, the Status for that camera would show that it is Connected. If it does not,
8.
click the Set button to verify that the parameters were entered correctly. You may also delete an added channel
by clicking the Delete button.
Click OK to exit out of the Camera Management menu.
9.
To adjust IP camera compression settings:
Enter the Record Settings menu, shown in Figure by clicking Menu > Setting > Record.
1.
Select the General tab.
2.
Select the IP camera to configure next to the Camera label.
3.
Adjust IP camera compression settings. If the IP camera was added successfully, the DVR will show OSD,
4.
channel name and the compression parameters in accordance to the IP camera's current settings.
Click OK to save and exit out of menu.
5.
Note:
The quality of resolution, frame rate and bit rate depends on the performance of the IP camera.
For more detailed information about the devices, refer to the full instruction manual inside the CD provided with the product.
DS1093-XXX
IP Channel Settings Menu
Camera Management Menu
Record Settings Menu
27