Prior To Operation - Hitachi DH 24PM Bedienungsanleitung

Drilling holes in concrete or tile
Drill bit (slender shaft)
Outer diameter Overall length
3.4 mm
90 mm
3.5 mm
SDS-plus Drill bit
Outer diameter Overall length
4.0 mm 110 mm
110 mm
5.0 mm
160 mm
5.5 mm 110 mm
6.5 mm 160 mm
7.0 mm 160 mm
8.0 mm 160 mm
8.5 mm 160 mm
9.0 mm 160 mm
166 mm
12.0 mm
260 mm
12.7 mm 166 mm
14.0 mm 166 mm
15.0 mm 166 mm
166 mm
16.0 mm
260 mm
17.0 mm 166 mm
19.0 mm 260 mm
20.0 mm 250 mm
22.0 mm 250 mm
Optional accessories are subject to change without notice.
APPLICATIONS
Rotation and hammering function
Drilling anchor holes
Drilling holes in concrete
Drilling holes in tile
Rotation only function
Drilling in steel or wood
Tightening machine screws, wood screws
Hammering only function
Light-duty chiselling of concrete, groove digging and
edging.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a power receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause a
serious accident.
Effective length
45 mm
Effective length
50 mm
50 mm
Outer diameter
100 mm
50 mm
100 mm
100 mm
100 mm
100 mm
100 mm
100 mm
* Without guide plate
200 mm
100 mm
100 mm
100 mm
100 mm
200 mm
100 mm
200 mm
200 mm
200 mm
3. Extension cord
4. Mounting the drill bit (Fig. 1)
CAUTION
NOTE
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner into the tool
(3) Check the latching by pulling on the drill bit.
(4) To remove the drill bit, fully pull the grip in the
5. Installation of dust cup or dust collector (B)
Drilling anchor holes
Taper shank adapter
Taper mode
Morse taper (No.1)
Morse taper (No.2)
A-taper
B-taper
Large hole boring
Core bit
Center pin
25 mm*
Not applicable
29 mm*
32 mm
35 mm (A)
38 mm
45 mm
(B)
50 mm
Anchor setting
Anchor setting adapter
Anchor size
W 1/4"
W 5/16"
W 3/8"
W 1/2"
W 5/8"
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
To prevent accidents, make sure to turn the switch
off and disconnect the plug from the receptacle.
When using tools such as bull points, drill bits, etc.,
make sure to use the genuine parts designated by
our company.
holder until it latches itself (Fig. 1).
direction of the arrow and pull out the drill bit (Fig. 2).
(Optional accessories) (Fig. 3, Fig. 4)
When using a rotary hammer for upward drilling
operations attach a dust cup or dust collector (B) to
collect dust or particles for easy operation.
English
Core bit shank
Overall length
105 mm
300 mm
300 mm
10