Kärcher K 7.20 MX Bedienungsanleitung Seite 16

Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g.
from water butts or ponds (see specifica-
tions for max. suction height).
Fill the KÄRCHER suction hose with
backflow valve with water, screw to wa-
ter supply and hang into he water butt.
Separate the high pressure hose from
the high pressure connection point of
the appliance.
Switch the appliance on "I/ON" and op-
erate until the water exits the high-pres-
sure connection without bubbles.
Turn off the appliance "0/OFF".
Start up
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the high-pressure pump.
Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
Illustration
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
16
English
Spray lance with pressure regulation
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max".
Release the lever on the trigger gun.
Turn the spray lance to the desired po-
sition.
Spray lance with dirt blaster
For particularly dirty items or areas.
Not suitable for use with detergents.
Washing brush
Suitable for use with detergents.
Working with detergent
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developped for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
Use spray lance with pressure regula-
tion (Vario Power).
Turn the spray lance to "Mix" position.
Fill the detergent solution in the deter-
gent tank (observe dosage instructions
on the packaging of the detergent).
Adjust the suction volume of the deter-
gent solution by means of the dosage
regulator for detergents.
- Medium quantity: Central position
- Large quantity: "+" position
- Small quantity: "-" position
Recommended cleaning method
Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
Spray off loosened dirt with the high-
pressure jet.