Operation; Switching Between Modes; 6�1�1 Display Icon For Each Mode; Basic Settings - Conrad 860112 Bedienungsanleitung

6.

Operation

6.1

Switching between modes

Press "Mode" button (B) to chose operation mode in the following sequence
starting from default (normal)�
The proper name of each mode is shown on the display for two seconds
before the mode is entered into� An icon appears on the display to indicate
each mode� All operating instructions under sections 5�x presume the
starting point to have been already set as under 5�1� Switch to the mode
indicate and begin operating procedures�
6.1.1 Display icon for each mode
If the icon is displayed on the LCD, the function is signifies is active.
6.2

Basic settings

1� Press the "Select" (A) button and hold it for 2 seconds, to set the
seconds� The seconds blink�
2� Press the "Start/Stop" (C) or "Split/Reset" (D) to reset the seconds to
"00"�
3� Press the "Mode" (B) button to confirm and set the minutes. The minutes
blink�
4� Press the "Start/Stop" (C) to increase or "Split/Reset" (D) to decrease�
5� Press the "Mode" (B) button to confirm and set the hours. The hours
blink�
6� Press the "Start/Stop" (C) to increase or "Split/Reset" (D) to decrease�
7� Press the "Mode" (B) button to confirm and set the month. The month
blinks�
22
Basic setting
Chronograph mode
Timer mode
Hourly alarm
Alarm mode
Pacer mode
Pacer memory
Lap memory