Pacer; 6�8�1 Pacer Setting & Display; 6�8�2 Using The Pacer - Conrad 860112 Bedienungsanleitung

7� Press the "Mode" (B) button to confirm and set the hours. The hours blink.
8� Press the "Start/Stop" (C) to increase or "Split/Reset" (D) to decrease�
9� Press the "Mode" (B) button to confirm and set the minutes. The
minutes blink�
10� Press the Start/Stop to increase or Split/Reset to decrease�
11� Press the "Mode" (B) button to confirm and set the hour format.
12� Press the Start/Stop or Split/Reset to change�
13� Press the "Select" (A) button at any time to exit the setting
procedure�
6.8

Pacer

Pacer setting can be done only if the stopwatch is not yet running in
pacer mode� The synchronization function with Chrono mode can only be
activated when the chronograph has been reset�
6.8.1 Pacer setting & display
Step length (in meter)
1� Press the "Select" (A) button and hold it for 2 seconds, the figures of
the beeper frequency blink�
2� Press the "Start/Stop" (C) or "Split/Reset" (D) to set the beeper
frequency in increments/decrements of 5 (range 30 - 240 bmp)�
3� Press the "Mode" (B) button to confirm and set the first digit of the
step length�
4� Press the "Mode" (B) button to confirm and set the second digit of the
step length�
5� Press the "Mode" (B) button to confirm and set the third digit of the step.
Determine your step length precisely before� The maximum value to be
set for the step length is 9�99 meter�
6.8.2 Using the pacer
Pacer operation with chronograph
1� Press "Split/Reset" (D)� The
function is now coupled to the chronograph� Whenever the chronograph
starts or stops the pacer does the same�
26
Beeper frequency (in bpm)
-icon appears in the display� The pacer
Total distance
Step counter