Transporting The Work Platform; Lifting By Crane; Moving By Forklift; Driving Or Winching Onto A Truck Or Trailer - Upright MX15 Betriebsanleitung

Transporting the Work Platform

T
RANSPORTING THE
Always use a transport vehicle when mov-
ing a machine to a work site. Towing the
machine over long distances will damage
the machine and void the warranty.
D A N G E R
!
See specifications for the weight of the
machine and be certain that the crane or
forklift is of adequate capacity to lift the
machine.
L
I F T I N G
Secure straps to chassis tie down/lifting
points only (refer to Figure 6).
M
O V I N G
IMPORTANT: Forklifting is for transport only.
Both the MX15 and MX19 may be fork-
lifted from the rear end of the machine between the wheels. They may also be forklifted from the side using
the forklift pockets shown in Figure 6.
D
R I V I N G O R
W A R N I N G
!
Never winch faster than 0,3 m/sec. (1 ft./sec.).
Never operate the machine with the parking brakes released. Serious injury or damage could result.
1. Loading the machine onto the truck or trailer;
A. To Drive the machine onto the transport vehicle:
a. Turn the Lift/Drive Switch to
b. Set the wheels straight and turn off the machine.
c. Chock the wheels.
B. To Winch the machine onto the transport vehicle:
a. Drive the machine up to the ramp.
b. Attach the winch cable to the tie down/lifting points.
c. Release the parking brakes (refer to "Parking Brake Release" on page 11).
d. Winch the machine into transport position
e. Chock the wheels.
f. Re-engage the parking brakes.
2. Secure the machine to the transport vehicle with chains or straps of adequate load capacity attached to
the chassis tie down/lifting points (refer to Figure 6).
C A U T I O N
Overtightening chains or straps attached to the Tie Down points may result in damage to the machine
Page 12
W
ORK
!
B C
Y R A N E
B F
Y O R K L I F T
W
I N C H I N G O N T O A
!
P
LATFORM
Figure 6: Crane Straps, Forklift Pockets and Tie Down / Lift Points
REAR
T
R U C K O R
and drive the machine up the ramp and into transport position.
113100-020 - MX15 / MX19 - Operation Manual
FRONT
T
R A I L E R