Battery Charging - Upright MX15 Betriebsanleitung

113100-020 - MX15 / MX19 - Operation Manual
B C
A T T E R Y H A R G I N G
Charge the batteries at the end of each work shift or
sooner if the batteries have been discharged.
W A R N I N G
!
Charge the batteries in a well ventilated area.
Do not charge the batteries when the machine is near a
source of sparks or flames.
Permanent damage to the batteries will result if the
batteries are not immediately recharged after
discharging.
Never leave the battery charger operating for more than
two days.
Never disconnect the cables from the batteries when the
charger is operating.
Keep the charger dry.
1. Check the battery fluid level. If the battery fluid level is lower than 10 mm (
plates add distilled water only.
2. Connect an appropriate extension cord to the charger outlet plug in the left module door.
Plug the extension cord into a properly grounded outlet of proper voltage and frequency
3. The charger turns on automatically after a short
delay. Look through the charge indicator cutout to
check the state of charge.
• 0 - 50% charge:
• First Light -BLINKING-
• Second and Third Light -OFF-
• 50% - 75% Charge:
• First Light -ON-
• Second Light -BLINKING-
• Third Light -OFF-
• 75% - 100% Charge:
• First and Second Light -ON-
• Third Light - BLINKING-
• Charge Complete
• All Lights -ON-
• The charger automatically shuts down to low cur-
rent after charging is complete and all lights turn ON.
• The charger continues at low current (equalizing charge) for 3-4 hours, then charging cur-
rent shuts off completely.
• Lights remain ON until the AC power supply is disconnected.
NOTE: The battery charger circuit must be used with a GFI (Ground Fault Interrupt) outlet.
NOTE: DO NOT operate the machine while the charger is plugged in.
!
Maintenance
Figure 10: Battery Charger
in.) above the
3
/
8
Figure 11: Charge Indicator Lights
Page 15