Handling And Operation; Charging Batteries - Tronic TLG 500 B1 Bedienungsanleitung

Handling and operation

In this chapter you will receive important information for the handling and opera-
tion of the device.

Charging batteries

♦ Place the device on a smooth, level and slip resistant surface.
♦ Compare the technical details with those of your power supplier. If they
match, insert the plug into a mains power socket. The LEDs
green once. The battery charger is now ready for use.
♦ Insert the batteries into the loading slots
into the loading slot
NOTICE
► 1 to 6 batteries can be individually charged:
- 4 x Type C or Type D in the loading slots
or
- 4 x Type AA or AAA in the loading slots
2 x Type 9 Volt Block batteries in the loading slots
♦ The charging process now begins. The battery charger has an LED
each compartment in the loading slot
loading slots
During the first 5 seconds the battery charger carries out a capacity test:
LED Colour
Green blinking
Red blinking
NOTICE
► Should the LED
then the battery is either not properly inserted into the loading slot
it is defective.
♦ When the battery capacity has been determined, the charging process begins.
TLG 500 B1
until they audibly engage.
show the charge status of the individual batteries.
Capacity of the
Green
Red
of the loading slot
. Press the 9 V Block batteries
1 to 4
1 to 4 and additionally
. The LEDs
battery
> 90 %
80 - 90 %
70 - 80 %
< 70 %
blink red for more than 5 seconds,
glow red and
5 and 6.
for
of the respective
or
│
7
■
GB