Specification; Dimensions And Connections - STIEBEL ELTRON DHM 3 Installation

INSTALLATION

Specification

Cleaning the strainer
You can clean the fitted strainer after removing the cold water
supply pipe.
Checking the earth conductor
f Check the earth conductor (in Germany e.g. BGV A3) on the f
earth conductor contact of the power cable and on the appli-
ance connector.
Appliance storage
f Store the dismantled appliance in a room free from the risk f
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
Replacing the power cable for the DHM 6
f If replacing the cable for the DHM 6, use a power cable with f
4 mm² cross-section
www.stiebel-eltron.com
9. Specification
9.1

Dimensions and connections

c01 c06
30
120
190
b02 Entry electrical cables I
b03 Entry electrical cables II
c01 Cold water inlet
c06 DHW outlet
20
b02
b03 82
DHM
Male thread G 3/8 A
Male thread G 3/8 A
DHM | 29