Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

EN
1. If you have not already done so, attach the desired suction nozzle to the telescopic
tube or suction hose (see chapter "Assembly", section "Mounting/removing suction
nozzles" and chapter "Product contents and device overview", section "Suction
nozzles").
2. Pull the mains cable out of the housing, ideally as far as the yellow mark but in any
case no further than the red mark on the cable!
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Press the
5. Move the nozzle over the surface you want to clean. You can pull the vacuum cleaner
like a sled when vacuum cleaning.
6. After vacuum cleaning, press the
7. Remove the mains plug from the mains socket, hold on to the mains cable and press
the cable retraction button
it from lashing against body parts such as your legs.
8. For optimum performance, empty the dust container after each use and clean
the cyclone insert, motor fi lters and HEPA exhaust air fi lter regularly (see chapter

"Cleaning and care").

Cleaning and care
ATTENTION!
Empty the dust container when it reaches the MAX mark and clean the cyclone in-
sert, motor fi lters and HEPA exhaust air fi lter regularly in order to prevent the motor
from overheating.
Prior to cleaning the device, always pull the mains plug out of the socket.
Keep the device, the mains cable and the mains plug away from water or other
liquids in order to avoid the risk of electrical shock. When cleaning the vacuum
cleaner make sure that no liquid gets into the device. Only the fi lters may be cleaned
with water. However, when fi tted back into the device they must be completely dry.
The fi lters are not suitable for the washing machine, dishwasher or dryer! Only air
dry the fi lters and do not under any circumstances use a hair dryer.
Do not use any corrosive or abrasive cleaners or cleaning pads for cleaning. They
could damage the surface.
Over time the fi lters may become discoloured. This is normal and does not
affect the functionality.
On/Off switch to turn the vacuum cleaner on.
Tipp: There is an auxiliary airfl ow vent on the handle.
Open this (by sliding the cover) in order to reduce the
suction power when vacuuming upholstery, carpets or
lightweight, easily movable objects.
The auxiliary airfl ow vent should normally be kept closed
so that the suction power is not unnecessarily reduced.
with your foot. By holding the mains cable, you prevent
20
On/Off switch again to turn off the device.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

C-320-70

Inhaltsverzeichnis