Power Switch - STUDER REVOX PR99 Bedienungsanleitung

OUICK
REFERENCE
OPERATING INSTRUCTIONS
REEL
MOUNTING
Three-pronged reel (DlN):
Mount supply
reel
on left-hand reel
support and empty take-up reel
on right-hand
reel support.
Pull
out three-pronged guide and lock
it
with
a 600 rotation.
NAB reels: Mount
NAB
adaptor
and
reelsupportand
lockthree-
pronged guide, Mount
NAB reel
on
adaptor
and turn
top section
of adaptor clockwise until it locks in place.
AEG
reel
flange:
Mount adaptor disk
on
the reel support and
lock
three-pronged guide.
Mountfull
reel on left-hand reel
support; lift
up
cover plate
and
rotate
by
90" until
it
rests on the
two guide pins. After completing
the preceding instructions, mount an empty core on
the right-
hand reel support.
Threading
of
tape:
Thread
tape according to opposite illustra-
tion
The tape must be threaded neatly around the
two
tape
guide pins
t5l
/
t6l.
Thread leading tape end
onto right-hand
reel
and manually rotate take-up reel in a counter-clockwise direc-
tion until the tape
is
locked.
Tape
f
itted with
a
transparent leader
should
be
wound
forward untilthe
start
of
the magnetic surface
has
passed the heads. Settape counterto
zero
by
depressing the
reset key
[4]
lil
OPERATING THE TAPE DECK
Apply power
to the tape deck by setting the POWER SWITCH [9]
to
the ON position, Select desired tape speed with
corre-
sponding button [B]. Playback
can
be started
by
touching
the
PLAY
key
[15].
The audio path
is automtically
swltched
on.
Fast
winding
is
initiated
with
key(
[13]
or)
[14].
These keys can
also
be used
to search for
a
particular tape section. The amplif ier
circuits are not active during fast
wind
operations.
The
STOP key
[16]
cancels the current operating mode.
The PAUSE key [12] suspends
the current operating mode
until
this key
is released.
Slide
[7] causes the tape
to
be
pressed againstthe sound-heads
and
switches
on the
reproduce amplifier. This mode
of
operation
(cutter mode)
is
used
for acoustically searching the desired cut-
ting position
During
the
search,
the tape can
be transported
through manual rotation
of
the spindles or under control
of the
spooling motors by depressing key
(
[13] or
]
1141.
The
cutter
mode can
be
terminated by depressinq the
PLAY
key
i'l51
or
by
pushing the pressure roller against the
capstan. The
tape deck
command
keys
function fully independently
and
do not require
the tape
to
be
stopped. This also applies
to the
tape speed
selec-
tor
[B].
When using
tape
reels
with
small hub diameters. the
REEL SIZE
switch
[10]
should
be depressed.
For
the so-called dump editing, the right-hand spooling
motor
can
be
switched off by depressing the
TAPE DUN/P
key
[11].
r{Elbx