Installing The Cp 1411 In The Pc/Programming Device; Important Notes - Siemens 6GK1141- 1AA00 Installationsanleitung

2

Installing the CP 1411 in the PC/Programming Device

2.1

Important Notes

Electrostatically
Sensitive Devices
Installing the
CP 1411
Reading the
Manual
Transceiver Power
Supply
Installationsanleitung CP 1411
C79000-Z8974-C24-05
When installing the module make sure that you avoid electrostatic
discharge (ESD).
Never open the PC/programming device or plug in or remove modules
when the power supply is on.
Before installing your module, please read the section in your
PC/programming device manual explaining how to install modules and
follow the instructions there.
The CP 1411 provides a voltage of 12 V at its AUI port to supply a
transceiver. The load on this should not exceed a continuous current of
500 mA.
Please remember that the maximum current of the 12 V power
supply must be limited to 8 A in the power supply unit of your
PC/PG.
Installation Instructions CP 1411
31