Siemens 6GK1141- 1AA00 Installationsanleitung Seite 37

Procedure
Step
1 Switch on your computer.
2 Insert the installation diskette in drive A:.
3 Go to the Control Panel of NT to the point where you can specify where the CP
1411 driver is located (Taskbar Start
Network Card
4 In the "Install from Disk" dialog box, type in the following:
A:\WINNT
Reaction:
The CP 1411 driver is loaded from diskette.
Possible Problems:
The installation diskette with the CP 1411 driver is in drive A, but you receive the
prompt to insert the CD in drive A.
Remedy:
Follow the steps below:
Step
1
2
3
5 During the installation, a dialog box appears in which you can choose between the
AUI (Attachment Unit Interface) or the TP or ITP cable (Twisted Pair/Industrial
Twisted Pair).
The default is the AUI cable. If you want to use a twisted-pair or Industrial Twisted-
Pair cable on the CP 1411, select the option "TP".
After you have installed the driver
After you have installed the driver, the list box "The following network components
are installed" includes the new network card with the name "AMD PCNET Family
Ethernet Adapter" (Taskbar Start
6
Install the required protocols (Taskbar Start
Network
Add Select Network Protocol
Installationsanleitung CP 1411
C79000-Z8974-C24-05
To install the CP 1411 driver under Windows NT, follow the steps be-
low:
Add Have Disk
Create a directory on the hard disk, for example "C:\CP1411".
Copy the Windows NT driver from diskette (for example: A\WINNT\*.*) to the
directory on the hard disk.
Repeat steps 3 and 4 (above) and then type in:
C:\CP1411
Network Card Select Network Component Type
Installation Instructions CP 1411
Procedure
Settings Control Panel
insert diskette).
Procedure
Settings Control Panel
Settings
etc.)
Section continued on the following page
Network
Network).
Control Panel
Protocol
37