Maintenance And Care - Kärcher KM 100/100 R Bp Pack Handbuch

Close wet/dry flap
Sweep in fibrous and dry waste (such as
dry grass, hay)
Open wet/dry flap.
Note: You can thus preven the filter system
from getting blocked.
Sweeping damp or wet floors
Open wet/dry flap.
Note: This protects the filter from moisture.
Filter dedusting
– Switch on manual filter shake off.
Press Filter shake off button. The filter
will be cleaned for 15 seconds.
Emptying waste container
Note: Wait until the filter shaking process is
finished and the dust has settled before you
open or empty the waste container.
Raise the waste container slightly and
pull it out.
Empty waste container.
Push in the waste container and lock it.
Empty opposite waste container.
Turn off the appliance.
Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.
Turn main key to "0" and remove it.
Note:Once the machine has been switched
off, the dust filter is shaken automatically
for approx. 15 seconds. Do not open the
machine hood during this period.
Note: The machine has been fitted with an
automatic parking brake that is activated as
soon as the engine is switched off and the
driver leaves his seat.
Transport
Danger
Risk of injury and damage! Observe the weight
of the appliance when you transport it.
Turn main key to "0" and remove it.
Secure the wheels of the machine with
wheel chocks.
Secure the machine with tensioning
straps or cables.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Note:Observe markings for fixing points on
base frame (chain symbols). When loading
or unloading the machine, it may only be
operated on gradients of max. 18%.
Storage
Danger
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Shutdown
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Park the sweeper on an even surface.
Set programme switch to step 1 (driv-
ing). The roller brush and side brushes
are raised to prevent the bristles being
damaged.
Turn main key to "0" and remove it.
Lock the sweeper to ensure that it does
not roll off.
Clean the inside and outside of the
sweeper.
Park the machine in a safe and dry
place.
Disconnect battery.
Charge battery and recharge it approx.
every 2 months.

Maintenance and care

General notes
First switch off the appliance, remove
the key and remove the battery plug or
disconnect the battery before perform-
ing any cleaning or maintenance tasks
on the appliance, replacing parts or
switching over to another function.
Pull out the battery plug or clamp the
battery while working on the electrical
unit.
– Maintenance work may only be carried
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety
regulations.
– Mobile appliances used for commercial
purposes are subject to safety inspec-
tions according to VDE 0701.
– Use only roller brushes/ side-brushes
that are provided with the appliance or
specified in the Operations Manual.
The use of other roller brushes/ side-
brushes can affect the safety of the ap-
pliance.
Cleaning
Caution
Risk of damage! Do not clean the appliance
with a water hose or high-pressure water
jet (danger of short circuits or other dam-
age).
Cleaning the inside of the machine
Danger
Risk of injury! Wear dust mask and protec-
tive goggles.
Open the hood, insert retaining rod.
7
-
EN
Clean machine with a cloth.
Blow through machine with com-
pressed air.
Close cover.
Note:The dust filter can be rinsed with water.
Dry the filter completely before reusing it.
External cleaning of the appliance
Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
Note: Do not use aggressive cleaning
agents.
Maintenance intervals
Note: The elapsed-time counter shows the
timing of the maintenance intervals.
Maintenance by the customer
Daily maintenance:
Check the sweeping roller and the side
brush for wear and wrapped belts.
Check tyre pressure.
Check function of all operator control el-
ements.
Weekly maintenance:
Check battery acid level.
Check for smooth running of the Bow-
den cables and the moveable parts
Check the sealing strips in the sweep-
ing area for position and wear.
Check dust filter and clean filter box, if
required.
Check the vacuum pressure system.
Maintenance to be carried out every 100
operating hours:
Check function of seat contact switch.
Check tension, wear and function of
drive belts (V-belt and circular belt).
Maintenance following wear:
Replace sealing strips.
Replace roller brush.
Replace side brush.
Note: For description, see section on Main-
tenance work.
Note:Where maintenance is carried out by
the customer, all service and maintenance
work must be undertaken by a qualified
specialist. If required, a specialised Archer
dealer may be contacted at any time.
Maintenance by Customer Service
Maintenance to be carried out after 8 oper-
ating hours:
Carry out initial inspection.
Maintenance to be carried out after 20 op-
erating hours
Maintenance to be carried out every 100
operating hours
Maintenance to be carried out every 300
operating hours
Maintenance to be carried out every 500
operating hours
Maintenance to be carried out every 1000
operating hours
Maintenance to be carried out every 1500
operating hours
Note: In order to safeguard warranty
claims, all service and maintenance work
during the warranty period must be carried
out by the authorised Kärcher Customer
Service in accordance with the mainte-
nance booklet.
23