Before Startup; Water Supply - Kärcher K 3.500 Bedienungsanleitung

3 Quick coupling for high pressure hose
4 Water connection with integrated sieve
5 Appliance switch "0/OFF"/ „I/ON"
6 Transport handle
7 Suction hose for detergent
8 Storage hook for high pressure hose and
mains connection cable
9 Mains cable with mains plug
10 Storage for accessories
11 Wheels
12 Trigger gun
13 Lock trigger gun
14 Key to detach the high-pressure hose
from the trigger gun
15 Spray lance with pressure regulation
(Vario Power)
16 Spray lance with Dirtblaster
17 Washing brush
18 Rotary washing brush
19 Delta-Racer D150
Special accessories
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Install wheels
Illustration
Push the wheels into the intake and se-
cure with the enclosed plugs, watch for
positioning of plug.
Install the transport handle
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Slide the transport handle into the guide
and secure it with 2 screws.
Attach the accessories net
Illustration
Hook the accessories net into the hooks
shown in the illustration.
Connect the high pressure hose to the
hand spray gun
Illustration
Push the high pressure hose into the trig-
ger gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.
Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is consid-
ered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For
protection, the use of the KÄRCHER water fil-
ter (optional accessory, order no. 4.730-059)
is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/techni-
cal data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Mini-
mum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
Screw the coupling element (supplied) to
the water connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water sup-
ply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g. from
water butts or ponds (see specifications for
max. suction height).
- 4
EN

Water supply

15