Customer Care - La Cornue CornuFé 90 Bedienungsanleitung

Assembling the Loose Parts
Fitting the Handrail
The hand rail is supplied as 2 end pieces with grub screws, 2
plastic friction cups and the rail tube.
Hold a friction cup by the tabs on one end of the tube. Fit one
of the end pieces to the tube and push it on the tube over the
friction cup.
Turn the tube over and fit the other end piece using the
second friction cup, making sure that you do not scratch or
damage the first end piece and the that the two end pieces
are lined up correctly.
Fit the assembled hand rail to the projecting mounting studs
on the control panel and fix it in place by tightening the grub
screws. The grub screws should be on the underside.
View from above
Fitting the Door Handles
Fit the door knobs to door knob bases and screw them on to
the mountings on the oven doors. Hand tighten only – do not
use any tools.
Fitting the Plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the range. Fasten the plinth using these
screws (alternative colour screws can be found in the loose
parts pack).

Customer Care

Please inform the user how to operate the cooker. Place
these instructions into the coloured CornuFé folder in the
instruction pack and hand them to the user.
Servicing
BEFORE SERVICING ANY GAS CARRYING
n n
COMPONENTS.
TURN OFF THE GAS SUPPLY.
n n
Check the appliance is gas sound after completion
n n
of service. When checking for gas leaks do not use
washing up liquid – this can corrode. Use a product
specifically manufactured for leak detection.
Do not use re-conditioned or unauthorised gas
n n
controls.
Disconnect from the electricity supply before
n n
commencing servicing, particularly before removing
any of the following: – control panel, side panels,
hotplate tray or any electrical components or covers.
Before electrical re-connection, check that the
n n
appliance is electrically safe.
Note – References to left-hand and right-hand oven apply as
viewed from the front.
1. To Remove the Hotplate
Disconnect the appliance from the electricity supply.
Remove pan supports and burner heads.
Undo the large brass nuts and remove the brass venturis. Lift
up the front of the hotplate top and disconnect the ignition
leads from the electrodes. Lift the hotplate clear of the
appliance.
Replace in reverse order.
2. To Remove the Control Panel
Disconnect the appliance from the electricity supply.
Remove the pan supports/hotplate accessories and burner
heads. Slacken the brass venturi at the centre of each burner.
Remove the control knobs from all taps.
Open both oven doors. Remove 3 fixings on the top front
and 3 fixings on the control panel underside. Pull the control
panel forward. Remove the connections from the rear of the
neons. Disconnect the earth lead and lift the panel clear of
the unit.
32
English