Troubleshooting - La Cornue CornuFé 90 Bedienungsanleitung

English
dry with a clean, soft cloth. Ensure all parts are dry before
repositioning.
Hotplate Burners
The burner heads can be removed for cleaning. Make sure
they are absolutely dry before replacing.
Burner head
Burner base
When fitting the burner head, make sure it locates properly
within the burner base.
Base of cooktop burner
If you look at the bottom of the burner head you will see two
'pips'; these fit into the two notches in the burner base.
Check burner ports are not blocked. If blockage occurs,
remove stubborn particles using a piece of fuse wire.
Griddle
Always clean the griddle after use. Allow to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS
n n
THESE WILL DAMAGE THE SURFACE.
Control Panel and Oven Doors
Avoid using any abrasive cleaners including cream cleaners,
on brushed stainless steel surfaces. For best results use liquid
detergents.
The control panel and control knobs should only be cleaned
Brass venturi
Bottom of burner head
25
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Cleaning Brass Parts
Uncoated natural brass is used as part of the authentic finish
on some models and this may tarnish with age. To regain
a polished finish, these areas should be cleaned using a
proprietary brass cleaner.
Ovens
Some of the lining panels can be removed for cleaning and
for cleaning behind.
Removing the Oven Linings
Remove the shelves first.
The side panels of the main oven can be removed.
Each side of the oven is fixed with four fixing screws. You do
not have to remove the screws to remove the oven linings.
Lift each side panel upwards and they will slide off the screws.
Then pull them forwards.
Once the linings are removed, the oven enamel interior can
be cleaned.
The Tall Oven
To clean the oven sides slide out the shelves, unhook the
supports from the oven sides and lift out.

Troubleshooting

Steam is coming from the oven
When cooking foods with a high water content (e.g. oven
chips) there may be some steam visible at the rear grille.
Take care when opening the oven door, as there may be a
momentary puff of steam when the oven door is opened.
Stand well back and allow any steam to disperse.
The oven fan is noisy
The note of the oven fan may change as the oven heats up –
this is perfectly normal.
The knobs get hot when I use the oven, can I avoid this?
Yes; this is caused by heat rising from the oven and heating
them up. DO NOT leave the oven door open.
If there is an installation problem and I do not get my
original installer to come back to fix it who pays?
You do. Service organisations will charge for their call outs if
they are correcting work carried out by your original installer.
It's in your interest to track down your original installer.
Food is cooking too slowly, too quickly, or burning
Cooking times may differ from your previous oven. Individual
tastes may require the temperature to be altered either way,
to get the results you want.
(Some Models Only)
(Left-hand Oven Only)