La Cornue CornuFé 90 Bedienungsanleitung Seite 31

Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
oven doors so that you can get a good grip on the bottom of
the fascia panel as you move the oven.
ArtNo.010-0004 Moving the cooker
Carefully push the cooker backwards off the base tray.
Remove the base tray. Position the cooker close to its final
position, leaving just enough space to get behind it.
Fitting the Flue Grille
The flue grille is packed separately. The larger of the holes
along the sides are for screwdriver access and should face to
the rear. Use the screws and nuts supplied to fix the grill in
place.
Clip the flexible extensions of the oven flues to the flue grille
using the clips provided inside the flue grille.
A dust cover is supplied packed in one of the ovens. Use
this to protect the cooker if the cooker cannot be installed
immediately.
Levelling
We recommend you use a spirit level on a shelf in one of the
ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
To adjust the height of the rear of the cooker, turn the
adjusting nuts at the front bottom corners of the cooker.
To set the front feet turn the bases to raise or lower.
Fitting the Stability Bracket or Chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown:
Restraining
Stability bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Outer stability
bracket
Wall
Typical wall mounting
30
chain
Cooker
3 mm min
Typical oor mounting
Cooker
3 mm min
English
Floor
Floor