Gas Connection; Electrical Connection - La Cornue CornuFé 90 Bedienungsanleitung

English
If you are using a stability chain then the chain should be
kept as short as is practicable and fixed firmly to the rear of
the cooker.
If you are using a stability bracket, then adjust the bracket to
give the smallest practicable clearance between the bracket
and the engagement slot in the rear of the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.

Gas Connection

Must be in accordance with the relevant standards. A hose is
not supplied by with the cooker. Hoses may be purchased at
most builders' merchants. The Gas supply needs to terminate
with a down-facing bayonet.
Because the height of the cooker can be adjusted and
each connection is different it is difficult to give precise
dimensions. The hose should be fitted so that both inlet
and outlet connections are vertical so that the hose hangs
downwards in a 'U' shape.
The connector is located just below the hotplate level at the
rear of the cooker ('A' in the diagram).
For Natural Gas the flexible hose must be in accordance with
BS 669.
For LP Gas it should be capable of 50 mbar pressure, 70 °C
temperature rise and carry a red stripe, band or label.
If in doubt contact, your supplier. Screw connect the threaded
end of the hose into the gas inlet.
After completing the gas connection, check the cooker is gas
sound with a pressure test.
Pressure Testing
The gas pressure can be measured at pressure test point 'B'
on the gas inlet. Turn off the gas supply to the cooker. Fit the
pressure gauge to the pressure test point. Turn on the gas
supply and light one of the hotplate burners.
Turn off the gas supply to the cooker and disconnect
pressure gauge

Electrical Connection

This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical Engineers
(I.E.E.) regulations and also the local electricity supply
company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED.
n n
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double-pole
switch having a contact separation of at least 3 mm in all
poles. This cooker must not be connected to an ordinary
domestic power point.
The total electrical load of the appliance is approximately
5.1 kW. The cable size used should be suitable for this load
and comply with all local requirements.
L
N
10 mm² max
ArtNo.130-0010 Electrical connections single-phase
230 V ac 50 Hz
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect the
mains cable to the correct terminals for your electrical supply
type. Check that the links are correctly fitted and that the
terminal screws are tight. Secure the mains cable using the
cable clamp.
Hotplate
Check each burner in turn. There is a flame safety device that
stops the flow of gas to the burner if the flame goes out. For
each burner, turn the control knob to the solid flame symbol.
Press in the control knob. This lets gas through to the burner.
Keep holding the knob pressed in and press the igniter
button or light with a match. Keep holding the control knob
pressed in for about 10 seconds.
If when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Oven Check
Turn on the ovens and check that they start to heat up.
Check that the oven lights are working.
Note: The oven light bulb is not included in the guarantee.
Turn off the ovens.
31