Operator's Duties; Instruction / Handover - Kessel SonicControl Anleitung

5.1 Getting the system ready for opera-
tion
Plug the mains plug of the control unit into
}
the socket. The system will initialise auto-
matically. During initial initialisation of the
system, the control unit requests four basic
settings.
1. Language
Correct enter
2. Date/time necessary for
measuring
3. Type of system*
4. Type of grease separator*
▲
▼
➤ Selection using
➤ Stored in system memory by pressing
"OK"
➤ After setting 1 to 4.
➤ Switch unit loads program memory
➤ Start operating mode
➤ System is ready for operation
* see page 29
5. Operation

5.2 Operator's duties

Checking
- for transport or installation damage
- for structural defects of all electrical
and mechanical components for seat and
function
- the cable connections
Customer instruction based on the in-
stallation and operating instructions
- Go through installation and operating in-
structions with the customer
- System operation (explaining
describing)
- Explanation to the customer about the
operator's duties
- Remind about regular servicing (see
chapter 6)
55

5.3 Instruction / handover

The chapter "Safety instructions" must
be heeded (page 4)!
Commissioning is carried out by a speciali-
sed firm or by an authorised KESSEL agent
(at an additional charge). The following per-
sons should be present for the handover:
- Person authorised to perform the accep-
tance on behalf of the building owner
- Specialised firm
and In addition, we recommend the participation
of operating personnel/operator and the
waste disposal contractor.
Summary of instruction:
- Get the system ready for operation
- Check the system
- Instruction based on the installation and
operating instructions
- Preparation of the handover certificate
(see chapter 13)
➤ Once instruction is completed, the sy-
stem must be made ready for operation.