Installation Of Sensor And Sensor Bracket - Kessel SonicControl Anleitung

3.2 Installation of sensor and sensor bracket

➊
Place the drilling template on the outside of the outlet structure and drill 2 x Ø 5,5 mm holes
(top two holes!).
Place the drilling template on the inside of the outlet structure and fix in place from the outside (see ).
Put the sensor and the pipe clamps together to the sensor bracket.
Screw the sensor bracket to the outlet structure using a torque of 1 Nm
and clip the sensor in place (see page 10).
3. Installation and Assembly
➋ ➌
43
➍
sensor bracket
PT screw Torx 40x12
PT screw Torx K 50x20
Pipe clamp PE d25
Drilling template/ screw cover
Outlet structure partition
SonicControl sensor
Red arrow marking