Kessel SonicControl Anleitung Seite 52

Possibilities of professional cable
extension on site (IP 68)
The SonicControl cable is ten metres long.
On site, this cable can be extended by a
qualified electrician up to max. 60 metres
without any change in cross-section being
necessary.
SonicControl probe extension to max. 60
metres 0,75 mm 2
Fig. 1: Crimp cable extension with butt joint
Fig. 2: Shell is placed around the cable, both shell ends are sealed
Fig. 3: Cast the shell with prepared casting resin
Fig. 4: Final state with sealing plug
Individual parts on request
4. Electrical connection
Note:
The regulations set out by the directive
VDE 0100 must be heeded. The switch
unit must not be installed in potentially
explosive areas. The 10 m cable can be
extended on site to up to 60 m. If the
cable is routed in a cable channel with
cables from other frequency-controlled
units, a shielded cable has to be used!
Fig.1
Fig.2
Fig.3
Fig.4
52