External Signal Generator; Electrical Connection; Potential-Free Switch Contact - Kessel SonicControl Anleitung

4. Electrical connection

4.1 1 External signal generator

4.3 Potential-free switch contact

The external signal generator (order no. 20162) for transmitting the
acoustic warning to other rooms can be connected if required.
4.2 Shortening the sensor cables
The sensor cables can be shortened if required. We only recom-
mend subsequently tin-plating the wire ends. When cable end
sleeves are used, care must be taken that the connection terminals
are designed for a max. cross-section of 2.5 mm 2 . This crosssec-
tion must not be exceeded.
50