Replacing The Lamp - AEG SANTO N 9 18 41-5i Benutzerinformation

Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.

Replacing the lamp

CAUTION!
Disconnect the plug from the mains socket.
Possible cause
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
FROSTMATIC or COOLMATIC
functions switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
What to do if...
Solution
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off FROSTMATIC or COOL-
MATIC manually, or wait to set the
temperature until the function
has reset automatically. Refer to
"FROSTMATIC or COOLMATIC
function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.
15