PeakTech 2510 Bedienungsanleitung Seite 38

2. It should be selected the "Current In Switch" (3-6, Fig. 1) to the "Clamp-On"
position, the display will show the marker "clamp1000A".
[Geben Sie ein Zitat
7.9. Data Hold
During the measurement, push the "Data Hold Button" (3-11, Fig. 1). It will hold the
display values and LCD will show the "HOLD" symbol.
* Push the "Data Hold Button" again, it will release the DATA HOLD function.
* Data Hold function is not available for ohm range.
7.10. Peak Hold
During the measurement, push the "Peak Hold Button" (3-10, Fig. 1). It will hold
the peak measurement values and LCD will show the "PK.H" symbol.
Peak Hold function is only available for the "Watt value".
* Push the "Peak Hold Button" again, it will release the Peak Hold function.
7.11. Alarm Setting
1. Alarm setting function is only for the "Watt" & "VA" display.
2. "Alarm Set Button" (3-15, Fig. 1) is used to set the max./min. alarm value or set
the alarm off (display does not show Max., Min. symbol when adjusting the Alarm
Set Button).
Fig. 4
-37-