PeakTech 2510 Bedienungsanleitung Seite 31

Marks:
ON = 1
~
AC =
3-1 LCD-Display
3-2 Power Switch
3-3 AC V/A Watt Switch
3-4 DC V/A Switch
3-5 Ohm Switch
3-6 Current In Switch
3-7 Watt/VA/Whr Button
3-8 Whr Zero Button
3-9 COS θ (Power Factor) / Hz Button
3-10 Peak Hold Button
3-11 Data Hold Button
3-12 Current Mode Button
3-13 "^" Button (Alarm Set)
3-14 ">" Button (Alarm Set)
3-15 Alarm Set Button
3-16 Watt Terminal
3-17 V/Ohm Terminal
3-18 COM Terminal
3-19 Current Terminal
3-20 Clamp-On Current Input Terminal
3-21 DC 9V Power Adaptor Input Socket
3-22 RS-232 Output Terminal
3-23 Battery Cover / Battery Compartment
6. Precautions & Preparations for Measurement
1. Ensure, that the batteries are connected correctly to its snap terminal and placed
in the battery compartment.
2. Select and push the correct switch and button before making measurements.
3. Place the test leads into the proper input terminal before making measurements.
4. Remove either of the test leads from the circuit under test while changing the
measurement function
5. Operate the instrument only in the ambient temperature range of 32° F – 122° F
(0° C – 50° C) and less than 80% Relative Humidity.
OFF = 0
DC =
.
-30-