Measuring Procedure - PeakTech 2510 Bedienungsanleitung

6. Do not exceed the maximum rated voltage of each range and input terminal.
7. Always switch the power to its "OFF"-position when the instrument is not in use.
Remove the batteries if not intend to use the instrument for a long period of time.

7. Measuring Procedure

Caution !
Do not apply the overload voltage,
current in the input terminal !
7.1. AC Watt/V/A/PF/Hz – Measurement
1. Push the "Power Switch" (3-2, Fig. 1) to "ON" position
ON = 1 OFF = 0
2. Select the "AC/V/A/Watt-Switch" (3-3, Fig. 1)
3. Select the "Current In"-Switch (3-6, Fig. 1) to the "DIRECT"-position
4. Do not make any wire connection to the input terminals. If the watt display is not
zero, push the "Whr-Zero Button" (3-8, Fig. 1) once, then watt display will show
"0".
Remark:
The "Whr-Zero Button" can be executed only under ACV & ACA are under
zero condition (no signal input).
5. Power off the "Power Source" of the measured installation.
Make the wire connection and connect the test leads into terminals (3-16, 3-17,
3-18, 3-19 – Fig. 2)
-31-