Dual DTFT 27-2 N Bedienungsanleitung Seite 118

Menu
When any item is selected with " " or " "
button in the install menu, the selected item
will be highlighted on the bottom bar.
Changes by pressing " " or " " button will
be result only at highlighted item on the bot-
tom bar.
Selecting Programme
To select programme number, you can use
" " or " " button, Digit Buttons or The
Double Digit button with digit buttons.
Install.
P 02 C-36 C 36 BG 252
Selecting Band
Band, can be chosen either,
• "C" or "S" by " " or " " button.
Selecting Channel
Channel can be changed by " " or " " but-
ton, by Digit Buttons or by the Double Digit
button with digit buttons.
For band C,
01 - 83, WEST EUROPE.
01 - 12, 21 - 69, EAST EUROPE .
01 - 17, 21 - 73, UK.
01 - 76, FRANCE.
04 - 09, FRANCE 2.
For band S,
ENG-2707W-1543 UK-27 INCH TFT (17MB08)-DUVAR MON-(WO PIP)(CHI MEI-B1).p65
01 - 41, for all channel tables.
Selecting Standard
Using " " or " " button on Standard, you
can change the standard to B/G, D/K, K', I/I',
L/L'.
Selecting Search
To start the search process, press " " but-
ton for forward search or "
backward search. If a signal is found or
reaches to end of the band after searching,
press " " or " " buttons to continue search
process. To stop the search process when
you want, press " " or " " buttons again.
Selecting Fine Tuning
You can use the Fine Tuning process for
fine adjustment (after coarse adjustment), if
you are not happy with the image on the
screen.
Use " " or " " button on Fine Tuning item,
until getting the best image on the screen.
Normally the Fine Tuning cursor is placed
next to the left side on the slider and this is
indicated with one arrow.
Setting VCR ( Video Cassette Recorder )
Mode
• This item can be seen in TV, AV-1, AV-2, AV-3,
S-VIDEO modes.
• If you want to watch a VCR source from one
of these modes, then it will be better to set
VCR mode "on". For this, while the cursor is
on this item press the " " or " " buttons to
set it "On".
• If you want to watch a DVD , then you must
set this item "off"; because DVD is not a
source like a VCR and to see the picture
better, you must set the VCR mode "Off".
To Store Settings
• Press "OK" button on the remote control to
store the settings directly.
or,
• Press " ", " " or "OK" button on Store op-
tion to store Install menu settings.
- 17 -
17
" button for
30.05.2006, 16:36