ended. Then, the program list on the screen
will show channels captured until this time.
If you do not accept the locations and / or the
programme names of programmes, you
can change them in Programme menu.
Operating with the buttons on the
TV set
Volume setting and programme selection
can be made by using the buttons at the
control panel on the top of the TV.
Volume Setting
• Press "- VOL." button to decrease volume or
"VOL. +" button to increase volume, so a vol-
ume level scale (slider) will be displayed at
the middle of the bottom on the screen.
Programme Selecting
• Press "P/CH +" button to select the next pro-
gramme or "- P/CH" button to select the pre-
vious programme.
Entering Main Menu
• Press "MENU" button to enter Main menu. In
the Main menu select submenu using
"- P/CH" or "P/CH +" button and enter the sub-
menu using "- VOL." or "VOL. +" button. To
learn the usage of the menus, refer to the
Menu System section.
Operating with Remote Control
The remote control handset of your TV is de-
signed to control all the functions of the
model you selected. The functions will be
described in accordance with the menu sys-
tem of your TV.
Functions of the menu system are de-
scribed in Menu System section.
Volume Setting
+" button to increase volume.
Press "
Press "-
" button to decrease volume. A
volume level scale (slider) will be displayed
at the middle of the bottom on the screen.
ENG-2707W-1543 UK-27 INCH TFT (17MB08)-DUVAR MON-(WO PIP)(CHI MEI-B1).p65
Programme Selecting
(Previous or next programme)
• Press "-P/CH" button to select the previous
programme.
• Press "P/CH+" button to select the next pro-
gramme.
Programme Selecting (direct access):
Press digit buttons on the remote control
handset to select programmes between 0
and 9. TV will switch to the selected program-
me. To select programmes between 10 - 99,
you must use the double digit button "- / - -".
P - -
hand upper on the screen.
After then, press the digit buttons consecu-
tively which programme you want to select
(eg. for programme 27, first press 2 and
then 7). When it is late to press any digit but-
ton this function will be ignored and the dis-
play will be erased. In the same way it must
not be late to press any digit button after en-
tering the first digit. The limit of the delay
time is 3 seconds.
Press directly the programme number to
reselect single digit programmes.
Programme Swapping
• Press "P<P" (programme swap) button to
select the last selected programme. This
button provides swapping between last two
selected programmes. For example, select
programme 8, then select programme 2.
Now, if you press "P<P" button, programme
8 will be selected. If you press the same
button again, programme 2 will be selected
and so on.
- 10 -
10
this OSD is displayed at the left
30.05.2006, 16:36