Hendi 281369 Gebrauchsanweisung Seite 8

Pause Mode
This mode allows users to pause the cycle to inspect
or stir the food. While the microwave is operating
open the door or press the ' ' button to pause the
cycle. The display will show the remaining time.
Run program mode
This microwave comes with 10 preset programs.
When the microwave is in 'ready mode' press one
of the number keys and the microwave will run the
program. Below you'll find the 10 preset programs.
Button
Display (Time)
Programming
This microwave can preset up to 99 programs. See
and follow "User options - 9 Double digit" session
for setting program no. from 10 to 99. Open the door,
then press and hold number "1" on the number key-
board for about 4 ~ 6 seconds, the buzzer will sound
and the display will show 'PROGRAM' to indicate you
entered program mode. Select the time with the '
EN
' button, the display will show "00:00", select the
requested time with the number keyboard. After
that, select the power level. Press the power level
buttons [0%/20% (defrost) /50%/70%], the display
will show the selected power. If you press again the
same power level button, the power will be back to
set 100% power . Also, if no power level button is
set, the power will be default to 100%. After setting
the time, power and press the 'u' button to save the
program. The display will show 'PROGRAM'. Close
the door to return to 'ready mode'. If you want to
cancel during programming, press the ' ' button
and the oven will return to the 'door open' mode and
the program won't be saved.
Below a quick guide how to make a program of 1.25
Double quantity (X2)
This microwave is equipped with a function to cal-
culate the amount of time needed when preparing
a double quantity of food. Press the 'X2' button fol-
lowed by the program and the microwave double the
8
1 2 3
0:10 0:20 0:30
To resume the cycle, close the door and press the
'start' button. When nothing is done the microwave
will go into idle mode.
When operating the microwave shows the remaining
time in the display, when it's a multi-stage program
the total remaining time will be displayed.
4 5 6
0:45 1:00 1:30
minutes at 70% power:
1) Open the door and press number button '1' for 5
seconds, display will show 'PROGRAM'.
2) Press number button '3', display shows P:03. Af-
ter 2 seconds the display will show the time relat-
ed with the program ':30'.
3) Press the number buttons '1' '2' '5' to set the
cooking time.
4) Press for the power level. The display will
show '1:25 70'.
5) Press the 'u' button. The program is now saved
under number keyboard '3'.
To overwrite the program repeat the steps above.
Note: Total programming time is limited to 60 min-
utes only.
Note: When the cooking time exceeds the maxi-
mum time the microwave can operate (standard
60 minutes) three beeps will be sound. This means
you need to adjust the time before the program can
work.
time you preset and start the process. This function
can only be used in combination with a preset pro-
gram.
7 8 9
2:00 2:30 3:00
0
3:30