Herunterladen Diese Seite drucken

Specifications; Operation And Adjustment - Monacor TVCCD-1000 COL Bedienungsanleitung

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB
(5)
Video signal output connector (BNC connector)
Connect to a TV monitor by using a coaxial cable.
(6)
Auto iris connector
Connect a cable from the lens if using an auto iris lens.
(7)
ES
0 - 4. 1/10000
A. 1/250
5. electronic iris
B. 1/500
6. off
C. 1/1000
7. flickerless
D. 1/2000
8. off
E. 1/4000
9. 1/125
F. 1/10000
(8)
AGC
ON: upper side
OFF: lower side
5. WIRING
1.
Connect a cable from the lens to the pin NO.1 to 4 of a 4-pin connector in accordance with
the following figures if using an auto iris lens.
4
1 DC + 12V
2 GND
3 NC
4 AI VIDEO
3
5
4
3
2 1
2.
Connect a cable from the VBS VIDEO OUT to 9-pin D Sub connector in accordance with the
following figures, however, do not connect a BNC connector to the VIDEO OUT at the same
9
8
7
6
time.
6 NC
1 GND
2 VIDEO OUT (VBS OUT)
7 NC
3 GND
8 EXT VD IN
9 EXT HD/EXT SYNC. IN
4 DC +12V
5 GND

6. OPERATION AND ADJUSTMENT

1.
Install lens to the camera.
2.
Connect a cable between the camera and the VIDEO monitor TV, and then turn on the
power of each device.
3.
To obtain the best possible picture, adjust the focus and the diaphragm, while observing the
image plane on the monitor TV when the picture appears.
4.
Back focus adjustment
This feature is being used if the subject is not in focus. Firstly, set the focus ring of the lens at
wide and take a picture of the subject at a distance of 20 m from the camera, while
4
2
observing the image plane on the monitor TV.
Secondly, loosen the screw of the front panel, which is used for tightening the lens mount
from the outside, and turn the lens and mount at the same time so that the subject is in
focus. Then firmly tighten the screw at the point where the subject is in focus.
3
1
(9)
WB
0 : 3200° K
1 : 5600° K
2 : 9000° K
3 : ATW
(10)
HP
Use it for the phase control of the
horizontal synchronization if
external sync. is used.
2
Do not use an auto iris lens of over 50 mA
of current consumption.
1
5
4
3
2 1
9
8
7
6

SPECIFICATIONS

Image Sensor
: 1/2" CCD-Chip (Colour)
Synchronization
: hor. 15625 Hz / vert. 50 Hz
Pixels
: hor. 500 x vert. 582
Resolution
: 330 Lines
Bandwidth
: 5,8 MHz, -6 dB
Min. Illumination
: 3,5 lux
S/N Ratio
: 48 dB
: 1 Vss/75 Ω
Video Output
1 Vss/10 Ω (Iriscontrol)
Operation Temperature : 0°C to +40°C
Power Supply
: 12 V DC, 230 mA, extern
MONACOR PS-12 CCD recommended.
Dimensions without lens : W 50 x H 43 x D 140 mm
Weight without lens
: 400 g
According to the manufacturer. Subject to technical change.
GB

Werbung

loading

Diese Anleitung auch für:

19.0690