Info; Reset Of The Home Server; Cleaning And Care - clage Home Server Gebrauchs- Und Montageanleitung

Use
( handwash = 35 °C,
Additionally the water flow is limited to 8 l/min (only devices with Servotronic®).

4.4.6 Info

The current status and device data are listed here.

4.5 Reset of the Home Server

For access to the Home Server, for example after having changed passwords, you must discon-
nect possibly connected LAN cables and pull out the power supply plug from the socket. Plug
in the power supply plug after an instant.
After the completed restart (which may take up to a minute), the Home Server is in the deliv-
ery status as access point for three minutes. During this time, the status LED will light up
continuously. For Wi-Fi configuration changes on the Home Server, you can log in your tab-
let / smartphone on the Home Server as follows:
Wi-Fi name = CLAGE-HS-... (followed by the last four digits of the MAC address printed on
the nameplate)
Password = Warmwasser
Note: If no changes are made in these three minutes, the Home Server automatically
starts the (Wi-Fi) configuration which was activated at last.

4.6 Cleaning and care

Do not subject the Home Server and its corresponding power pack to humidity. Otherwise
you risk damage to the electricity. For any cleaning which is required nevertheless, you must
remove the plug from the socket and use a soft and dry cloth for wiping the surfaces. Do not
use any solvents for cleaning.
shower = 38 °C, bath = 42 °C,
45 / 52
hot water = 48 °C).
CLAGE