Connecting The Home Server Via Wi-Fi (Client Mode); Connecting The Home Server Via Lan Cable - clage Home Server Gebrauchs- Und Montageanleitung

Home Server with Control-App "Smart Control"
Use

4.2.1 Connecting the Home Server via Wi-Fi (client mode)

1. Enter the device configuration (Main menu → Settings → Devices), select the Home Server
which you would like to configure. Open the "Advanced" tab and select the operating mode
"Client".
2. At the menu "Network" all networks found in range will be listed. Tap on your SSID to select
your home network. If the SSID of your home network is hidden, it must be temporarily set
to "visible" during the configuration.
3. Enter your Wi-Fi password under "Password" and tap on "Apply".
4. The Home Server updates the Wi-Fi settings and tries to log in on the router using the new
access data. The tablet / smartphone will log in on the home network automatically after
switching. Close the Smart Control app and check the Wi-Fi connection of the tablet / smart-
phone in the Wi-Fi settings.
5. Return to the control app. After the successful log-in on the home network, the IP address
below the MAC address of the Home Server has changed and the status LED goes off.
6. In the control app you can check the successful installation by tapping on "Connect" in the
settings of your Home server in the configuration menu. The following text should appear:
"Home Server can be used."
Note: The Home Server returns to the access point mode after a short while if it is not
possible to log in with the entered access data (the status LED remains on). Reconnect
your tablet / smartphone with the Home Server and check the access data.
If the Wi-Fi on which the Home Server has been logged in is no longer accessible (e.g.
because the router has been switched off or the password of the home network has
been changed), the Home Server will start as stand-alone access point when switched
on the next time. In this case, it is possible to access the Home Server with the access
data listed in the "Initial operation" chapter. Then you can log in the Home Server on
another network.

4.2.2 Connecting the Home Server via LAN cable

1. Connect the LAN cable to one of the four Ethernet terminals at the right side of the Home
Server and to one of the open network terminals at your router.
2. The Home Server will automatically deactivate its Wi-Fi connection and switch to client
mode. The status LED goes off.
3. Ensure your tablet / smartphone is connected in the same network.
4. In the control app you can check the successful installation by tapping on "Connect" in the
settings of your Home server in the configuration menu. The following text should appear:
"Home Server can be used."
38 / 52