Installation; Prerequisites; Place Of Installation - clage Home Server Gebrauchs- Und Montageanleitung

Home Server with Control-App "Smart Control"

Installation

3. Installation
The installation, initial operation and maintenance of the device may only be carried out by an
approved qualified servicing company which is fully responsible for the compliance with appli-
cable standards and installation provisions. We do not assume any liability for damage caused
by the non-compliance with these instructions!

3.1 Prerequisites

The following is required for the use of the Home Server:
• At least one instantaneous water heater of the series DSX Touch, DSX Twin, DSX, DEX, CFX,
CEX, MCX or MBX manufactured after 1st April 2013 (the date of manufacture is indicated
by the 12-digit serial number xDDDDD-xxxxxx: if DDDDD ≥ 13091, then the device was
manufactured after 1st April 2013.)
• For the use with the Home Server, the instantaneous water heater must be equipped with
a radio module. The radio module is incorporated in the DSX Touch, DSX Twin, DSX and CFX
series ex works; for any other series mentioned above, it can be acquired as accessory part
(order number 3200-34031 for devices from 2013 – 2016 or order number: 3200-34035 for
devices from 2017 when DDDDD ≥ 170101) and retrofitted by a specialist.
• A tablet / smartphone with iOS 9 or Android-OS 4.4 operating system must be available.
• For the installation of the control app, an access to the Apple AppStore or an access to the
Google Playstore is also required.

3.2 Place of installation

Make sure that, at the intended place of installation, a socket is available within the reach
of the power supply cable (approx. 1.70 m), and that all desired instantaneous water heaters
are positioned at a distance of less than 10 m to the intended place of installation. The Home
Server can be used either horizontally on a solid ground or vertically mounted on the wall.
Note: Do not use the device in the vicinity of disturbing sources such as microwaves, or
in the direct vicinity of metallic surfaces. Otherwise the safe and reliable radio contact
and the optimal radio range cannot be ensured.
32 / 52