Technical Data; Environment Concerns - Electrolux MGVS6100 Benutzerinformation

32
Problem
The dishes are wet.
The dishes are wet and dull.
How to activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights for function but-
tons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons
A and C go off.

Technical data

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of the
appliance door shows the electrical con-
nection data.
If the hot water comes from alternative
sources of energy, (e.g. solar panels,

Environment concerns

The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will help
prevent potential negative consequences for
the environment and human health, which
Possible cause
The detergent can be the cause. Use a different brand of deter-
You have set a washing pro-
gramme without drying phase or
with a decreased drying phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on. (The
rinse aid dispenser is automati-
cally off).
6. Press function button B again.
7. Switch off the appliance to keep the op-
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
could otherwise be caused by inappropriate
waste handling of this product. For more
detailed information about recycling of this
product, please contact your local council,
your household waste disposal service or the
shop where you purchased the product.
Recycle the materials with the symbol
Put the packaging in applicable containers to
recycle it.
Possible solution
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispenser.
Refer to 'How to activate the
rinse aid dispenser'.
– The indicator light for function button B
continues to flash.
– The end-of-programme indicator light
comes on.
eration.
To deactivate the rinse aid dispenser, do
the same procedure until the end-of-
programme indicator light goes off.
photovoltaic panels and aeolian), use a
hot water supply to decrease energy
consumption.
596 mm
858 - 938 mm
550 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60 °C
12
.