Use Of The Appliance; Setting The Water Softener - Electrolux MGVS6100 Benutzerinformation

22
• To activate/deactivate the multitab func-
tion.
• To activate/deactivate the rinse aid dis-
penser.
• To deactivate/activate the audible signals.
Press the on/off button. The appliance is in
setting mode when:
– All the programme indicator lights come
on.
Press the on/off button. The appliance is not
in setting mode when:
– Only one programme indicator light comes
on.
– It is necessary to cancel the programme
or the delay start to go back to the set-
ting mode. Refer to 'Select and start a
washing programme'.
Audible signals
The audible signals indicate:
• The end of the washing programme.
• The electronic adjustment of the level of
the water softener
• The appliance has a malfunction.
Do these steps to deactivate the audible sig-
nals:

Use of the appliance

Refer to the instructions for each step of pro-
cedure:
1. Make a check if the adjustment of the
water softener agrees with the water
hardness in your area. If necessary, ad-
just the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the appli-
ance.

Setting the water softener

The water softener removes minerals and
salts from the water supply. Minerals and
salts can have a bad effect on the operation
of the appliance.
Equivalent scales measure the water hard-
ness:
• German degrees (dH°).
Water hardness
°dH °TH
51 - 70 91 - 125
mmol/l Clarke
9,1 - 12,5 64 - 88
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons A and B.
5. Press the function button C.
– The indicator lights for function buttons
A and B go off.
– The indicator light for function button C
flashes.
– The end-of-programme indicator light
comes on.
• The audible signals are active.
6. Press the function button C again.
– The end-of-programme indicator light
goes off.
• The audible signals are deactivated.
7. Switch off the appliance to keep the op-
eration.
Do the above procedure to activate
again the audible signals.
5. Set the correct washing programme for
the type of load and soil.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
If you use the combi detergent tablets ('3
in 1', '4 in 1', '5 in 1'), refer to 'Multitab
function'.
• French degrees (°TH).
• mmol/l (millimol for each litre - international
unit for the hardness of water).
• Clarke degrees.
Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
Water hardness adjustment
manually
1)
2
electronically
10