What To Do If - Electrolux MGVS6100 Benutzerinformation

30
7. Put the filter system in position.
8. To lock the filter system, turn the handle
on the microfilter (B) clockwise until it
locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
cocktail stick.

What to do if...

The appliance does not start or stops during
operation.
Malfunction
The appliance • The Indicator light of the
does not fill with
water.
• The end-of-programme
The appliance • The Indicator light of the
does not drain
the water.
• The end-of-programme
The anti-flood • The Indicator light of the
device operates.
• The end-of-programme
Fault code
programme in progress
flashes.
indicator light flashes one
time.
programme in progress
flashes.
indicator light flashes two
times.
programme in progress
flashes.
indicator light flashes
three times.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(e.g. acetone).
First try to find a solution to the problem (refer
to the chart). If not, contact the service cen-
tre.
Possible cause
The water tap is blocked
or is furred with lime-
scale.
The water pressure is
too low.
The water tap is closed.
The filter in the water in-
let hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is not
correct.
The water drain hose is
damaged.
Possible solution
Clean the water tap.
Contact your local water
authority.
Open the water tap.
Clean the filter.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter inlet hose has no
damages.
Clean the sink spigot.
Make sure that the con-
nection is correct.
Make sure that the wa-
ter drain hose has no
damages.
Close the water tap and
contact the service cen-
tre.