Troubleshooting - Kenwood KMM-BT203 Bedienungsanleitung

TROUBLESHOOTING

Symptom Remedy
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING Turn the power off, then check to be sure the
THEN PWR ON" appears. terminals of the speaker wires are insulated properly.
Turn the power on again.
"PROTECTING SEND SERVICE" Send the unit to the nearest service center.
appears.
• Sound cannot be heard. Clean the connectors. ( 22)
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all. Reset the unit. ( 3)
• Radio reception is poor. Connect the antenna firmly.
• Static noise while listening
to the radio.
"READING" keeps flashing. Do not use too many hierarchical levels or folders.
Elapsed playing time is not This is caused by how the files are recorded.
correct.
"LOADING" appears when you This unit is still preparing the iPod/iPhone music list.
enter search mode by pressing It may take some time to load, try again later.
.
Correct characters are not • This unit can only display uppercase letters,
displayed (e.g. album name).
• Depending on the display language you have
"NA FILE" Make sure the media contains supported audio files.
( 22)
20 ENGLISH
numbers, and a limited number of symbols.
selected ( 5), some characters may not be
displayed correctly.
Symptom Remedy
"READ ERROR" Copy the files and folders onto the USB device again. If this
does not solve the problem, reset the USB device or use
another USB device.
"NO DEVICE" Connect a USB device, and change the source to USB again.
"COPY PRO" A copy-protected file is played.
• Check whether the connected device is compatible with
"UNSUPPORTED DEVICE"
appears. this unit and ensure the file systems are in supported
formats. ( 22)
• Reattach the device.
"UNRESPONSIVE DEVICE" Make sure the device is not malfunction and reattach the
appears device.
"USB HUB IS NOT This unit cannot support a USB device connected via a
SUPPORTED" appears. USB hub.
"NO MUSIC" Connect a USB device that contains playable audio files.
"iPod ERROR" • Reconnect the iPod.
• Reset the iPod.
• Sound cannot be heard • Reconnect the Android device.
• If in [HAND MODE], launch any media player
during playback.
• Sound output only
application on the Android device and start playback.
from the Android • If in [HAND MODE], relaunch the current media player
device. application or use another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected
Android device is unable to route the audio signal to
unit. ( 22)