Change The Display Information; Troubleshooting - Kenwood KMM-BT408DAB Bedienungsanleitung

References

Change the display information

Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name) appears or display will be blank.
Source name Display information: Main display
STANDBY Source name/Clock
DIGITAL AUDIO Source name/Clock
Song title/Artist
beginning
RADIO Source name/Clock
FM Radio Data System stations only:
Source name/Clock
Radio text+ Radio text+ song title/Radio text+ artist
Clock back to the beginning
USB For MP3/WMA/WAV/FLAC files:
Source name/Clock
name File name
BT AUDIO Source name/Clock
time Clock back to the beginning
AUX Source name/Clock
Main display
Clock back to the beginning
Service label Ensemble label Dynamic label
Next program Signal level Clock
Frequency Clock back to the beginning
Station name/Program type Radio text
Frequency
Song title/Artist Album title/Artist Folder
Playing time Clock back to the beginning
Song title/Artist Album title/Artist Playing
Clock back to the beginning

Troubleshooting

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
back to the
The unit does not work at all.
Correct characters are not
displayed.
DAB reception is poor.
"DAB ANT ERR"
"RELATED SERV FOUND"
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 5)
Clean the connectors. (Page 30)
Reset the unit. (Page 3)
• This unit can only display uppercase letters, numbers,
and a limited number of symbols.
• Depending on the display language you have selected
(page 6), some characters may not be displayed
correctly.
Make sure [ON] is selected for [DAB ANT POWER].
(Page 5)
Check the DAB antenna. If a passive antenna (without
a booster) is used, set [DAB ANT POWER] to [OFF].
(Page 5)
• Press the volume knob to activate Soft-Link. (Page 8)
• Press to cancel.
ENGLISH
31