Set The Clock And Date; Set The Initial Settings - Kenwood KMM-BT203 Bedienungsanleitung

GETTING STARTED
2

Set the clock and date

1 Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [CLOCK], then press the knob.
To adjust the clock
3
Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Hour Minute
5 Turn the volume knob to select [CLOCK FORMAT], then press the knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
To set the date
7
Turn the volume knob to select [DATE FORMAT], then press the knob.
8
Turn the volume knob to select [DD/MM/YY] or [MM/DD/YY], then press
the knob.
9 Turn the volume knob to select [DATE SET], then press the knob.
10
Turn the volume knob to make the settings, then press the knob.
Day Month Year or Month Day Year
11 Press and hold to exit.
To return to the previous setting item, press
3

Set the initial settings

1 Press repeatedly to enter STANDBY.
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select an item (see the following table),
then press the knob.
4 3
Repeat step until the desired item is selected or activated.
5 Press and hold to exit.
To return to the previous setting item, press
4 ENGLISH
AUDIO CONTROL
SWITCH
PREOUT
TUNER SETTING
PRESET TYPE
SYSTEM
KEY BEEP
SOURCE SELECT
BUILT-IN AUX
.
P-OFF WAIT
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx
.
FACTORY RESET YES: Resets the settings to default (except the stored station). ;
(Not applicable if 3-way crossover is selected.)
REAR/SUB-W: Selects whether rear speakers or a subwoofer are
connected to the line out terminals on the rear (through an external
amplifier). ( 26)
NORMAL: Memorizes one station for each preset button in each band
(FM1/FM2/FM3/MW/LW). ; MIX: Memorizes one station for each preset
button, regardless of the selected band.
(Not applicable if 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AUX in source selection. ; OFF: Disables. ( 9)
Applicable only when the demonstration mode is turned off.
Sets the duration when the unit will automatically turn off (while in
standby mode) to save the battery.
20M: 20 minutes ; 40M: 40 minutes ; 60M: 60 minutes ; – – –: Cancels
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<www.kenwood.com/cs/ce/>.
NO: Cancels
Default: XX