Change The Display Information; Troubleshooting - Kenwood KDC-BT960DAB Bedienungsanleitung

References

Change the display information

Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name) appears or display will be blank.
Clock time
Source name Display information: Main display
STANDBY Source name Date
DIGITAL AUDIO Service label Ensemble label
Next program
RADIO Frequency Date
For FM Radio Data System stations only:
Station name/Program type
song title/Radio text+ artist
beginning
CD or USB For CD-DA:
Disc title/Artist
beginning
For MP3/WMA/AAC/WAV/FLAC files:
Song title/Artist
Playing time Date
iPod USB/iPod BT Song title/Artist
the beginning
BT AUDIO/ALEXA Song title/Artist
the beginning
AUX Source name Date
38
ENGLISH
Main display
back to the beginning
Dynamic label Song title/Artist
Signal level Date back to the beginning
back to the beginning
Radio text Radio text+
Frequency Date back to the
Track title/Artist Playing time Date
Album title/Artist Folder name File name
back to the beginning
Album title/Artist Playing time Date
Album title/Artist Playing time Date
back to the beginning

Troubleshooting

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND
SERVICE" appears.
Source cannot be selected.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work
at all.
Correct characters are not
Radio text+
displayed.
back to the
DAB reception is poor.
"DAB ANT ERR"
back to
"RELATED SERV FOUND"
back to
• Radio reception is poor.
• Static noise while
listening to the radio.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 5)
Clean the connectors. (Page 36)
Reset the unit. (Page 3)
• This unit can only display uppercase letters, numbers,
and a limited number of symbols.
• Depending on the display language you have selected
(page 6), some characters may not be displayed
correctly.
Make sure [ON] is selected for [DAB ANT POWER].
(Page 5)
Check the DAB antenna. If a passive antenna (without
a booster) is used, set [DAB ANT POWER] to [OFF].
(Page 5)
• Press the volume knob to activate Soft-Link. (Page 8)
• Press to cancel.
Connect the antenna firmly.