Kenwood Multipro FP910 series Bedienungsanleitungen Seite 5

before using your Kenwood appliance
Read these instructions carefully and retain for future
●
reference.
Remove all packaging and any labels.
●
safety
The blades and discs are very sharp, handle with care.
●
Always hold the knife blade by the finger grip
at the top, away from the cutting edge, both
when handling and cleaning.
Do not lift or carry the processor by the handle - or the
●
handle may break resulting in injury.
Always remove the knife blade before pouring contents from
●
the bowl.
Keep hands and utensils out of the processor bowl and
●
liquidiser jug whilst connected to the power supply.
Switch off and unplug:
●
before fitting or removing parts
● ●
after use
● ●
before cleaning
● ●
Never use your fingers to push food down the feed tube.
●
Always use the pusher/s supplied.
Before removing the lid from the bowl or liquidiser or mini
●
chopper/mill from the power unit:-
switch off;
● ●
wait until the attachment/blades have completely
● ●
stopped;
be careful not to unscrew the liquidiser jug or mini
● ●
chopper/mill from the blade unit.
Liquids should be allowed to cool to room temperature
●
before blending.
Do not use the lid to operate the processor, always use the
●
on/off speed control.
This machine will be damaged and may cause
●
injury if the interlock mechanism is subjected to
excessive force.
Never use an unauthorised attachment.
●
Never leave the machine on unattended.
●
Never use a damaged machine. Get it checked or repaired:
●
see 'service'.
Never let the power unit, cord or plug get wet.
●
Don't let excess cord hang over the edge of a table or
●
worktop or touch hot surfaces.
Do not exceed the maximum capacities stated.
●
This appliance is not intended for use by persons (including
●
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
●
play with the appliance.
Only use the appliance for its intended domestic use.
●
Kenwood will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
Misuse of your processor/liquidiser can result in injury.
●
before plugging in
Make sure your electricity supply is the same as the one
●
shown on the underside of your machine.
This appliance conforms to EC directive 2004/108/EC on
●
Electromagnetic Compatibility and EC regulation no.
1935/2004 of 27/10/2004 on materials intended for contact
with food.
before using for the first time
1 Remove all packaging including the plastic blade covers
from the knife blade. Take care the blades are very
sharp. These covers should be discarded as they are to
protect the blade during manufacture and transit only.
2 Wash the parts see 'cleaning'
3 Push excess cord into the back of the machine.
key
processor
power unit
detachable drive shaft
bowl
lid
feed tube
pushers
safety interlocks
cord storage
speed control with power on light
liquidiser
filler cap
lid
jug – plastic (FP910) & Glass (FP920)
sealing ring
blade unit
mini chopper/mill
mill lid
jar
additional attachments
Not all of these attachments listed below will be included
with your food processor. To buy an attachment not
included in your pack, contact the dealer from whom you
purchased your appliance.
knife blade
dough tool
twin beater geared metal whisk
maxi-blend canopy
thick slicing/coarse shredding disc
thin slicing/fine shredding disc
fine (Julienne style) chipper disc
rasping disc
geared citrus press
mini processor bowl
centrifugal juicer
KENSTORE™ attachments carousel
3
(FP920)