Lej HXP 120 V Bedienungsanleitung Seite 43

HXP 120 V
slowly be moved towards the lamp. Make sure that the connecting cables of the lamp
(Figure 3[3]) do not contact the reflector or block the venting grate (Figure 3[5]). To ensure
this, install the front connecting cable of the lamp (at the light exit side) behind the air
baffle (Figure 3[4]). When the lamp is installed and the plug connection made, the housing
cover can be closed.
For removing the lamp it is recommended to lightly force the two parts of the plug (Figure 3
[1.2]) apart with a suitable screwdriver because the connection is very tight. During this,
press down the locking lever at the plug (Figure 3[2]). Apply the screwdriver in such a way
that when it slips only the lamp-side plug is damaged (Figure 3[2]) and not the socket
(Figure 3[1]) as the latter is replaced together with the lamp.
1
1 Socket
2 Lamp-side plug
Figure 3: Device with housing cover removed; lamp installed
Start-up
Installing and changing the lamp
3 Connecting cables
4 Air baffle
Leistungselektronik
2 3 4
5 Fan grate
JENA GmbH
5
43 von 52