EuroLite 50532040 Bedienungsanleitung Seite 19

1
Fix the LED strip at a desired place by means of the self-adhesive foil
on the rear side. The installation place should be clean, dry and free
of grease. Various profile frames are available as accessory. Always
remove the adhesive backing, otherwise the LEDs may be damaged
through heat build-up.
2
Connect the wires at the LED strip to the terminals of the control unit
according to their color:
white = negative pole for the white LEDs
blue = negative pole for the blue LEDs
green = negative pole for the green LEDs
red = negative pole for the red LEDs
black = common positive pole
The maximum load of each of the four output channels (R, G, B, W)
by the LEDs must not exceed 6 A. Overload will damage the control
unit.
3
Connect the supplied power supply unit to power input at the control
unit and to a mains outlet.
4
The LED strip can be cut with scissors at
the cutting marks between sets of soldering
points. LED strips can be connected by
soldering or using solderless clamps
(commercially available). Assign this task to
a skilled professional. For custom-made
versions, please make sure that the power
supply unit and the current-carrying cables
of the set are not overloaded.
5
The wireless remote control requires two 1.5 V batteries size AAA.
Remove the cover of the battery compartment and insert two batteries
as indicated in the compartment. The remote control needs to be
assigned to the control unit when taking the set into operation (
chapter 5).
Danger of explosion when battery is replaced improperly. Only
replace by the same type. Please dispose of old and used
batteries properly. Batteries are hazardous waste and should not
be disposed of with regular domestic waste!
www.eurolite.de
CAUTION!
19