How To Activate The Rinse Aid Dispenser; Technical Information - Electrolux ESL 6601RA Benutzerinformation

Stains and dry water drops on
glasses and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a different
brand or activate the rinse aid dispens-
er and use rinse aid together with the
combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.

11. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
1. Press the on/off button to activate the
appliance.
2. Make sure that the display shows the
programme P1. If the display shows a
different programme, press and hold
touchpads (4) and (5) until P1 shows
in the display.
3. Press and hold touchpads (4) and (5)
at the same time until the indicators of
touchpads (3), (4), (5) and (6) flash.
4. Press touchpad (4).
• The indicators of touchpads (3), (5)
and (6) go off.
• The indicator of touchpad (4) contin-
ues to flash.
• The display shows the current set-
ting.
Rinse aid dispenser off
Rinse aid dispenser on
5. Press touchpad (4) to change the set-
ting.
6. Deactivate the appliance to confirm
the setting.
7. Adjust the released quantity of rinse
aid.
8. Fill the rinse aid dispenser.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
2)
ENGLISH 35
220-240 V
50 Hz
max. 60 °C
12
0.10 W
0.10 W